From field analysis to nanostructural investigation: A multidisciplinary approach to describe natural occurrence of asbestos in view of hazard assessment.

The environmental impact of natural occurrences of asbestos (NOA) and asbestos-like minerals is a growing concern for environmental protection agencies. The lack of shared sampling and analytical procedures hinders effectively addressing this issue. To investigate the hazard posed by NOA, a multidisciplinary approach that encompasses geology, mineralogy, chemistry, and toxicology is proposed and demonstrated here, on a natural occurrence of antigorite from a site in Varenna Valley, Italy. Antigorite is, together with chrysotile asbestos, one of the serpentine polymorphs and its toxicological profile is still under debate. We described field and petrographic analyses required to sample a vein and to evaluate the NOA-hazard. A combination of standardized mechanical stress and automated morphometrical analyses on milled samples allowed to quantify the asbestos-like morphology. The low congruent solubility in acidic simulated body fluid, together with the toxicity-relevant surface reactivity due to iron speciation, signalled a bio-activity similar or even greater to that of chrysotile. Structural information on the genetic mechanism of antigorite asbestos-like fibres in nature were provided. Overall, the NOA site was reported to contain veins of asbestos-like antigorite and should be regarded as source of potentially toxic fibres during hazard assessment procedure.

Chrysotile asbestos migration in air from contaminated water: An experimental simulation.

In Naturally Occurring Asbestos (NOA) rich areas, water flows through asbestos bearing rocks and soils and generates waterborne fibres that may migrate in air and become a risk for humans. Research on the migration and dispersion after water vaporisation has been so far only marginally evaluated. This study investigates the migration in air of asbestos from a set of suspensions contaminated by chrysotile from Balangero (Italy), under controlled laboratory conditions. We evaluated i) the morphological modifications that might occur to chrysotile during migration from water to air, and ii) the amount of airborne chrysotile mobilised from standardised suspensions. Morphological alteration of asbestos fibres occurred during water-air migration and impacted on the analytical response of electron microscopy. Waterborne asbestos concentration higher than 40 ∙ 106 f/L generates in air concentration higher than 1 fibre per litre [f/L], the alarm threshold limit set by World Health Organization for airborne asbestos. A possible correlation between the waterborne fibre concentration as mass or number of fibres per volume unit [µg/L or f/L] was observed.

Evaluation of the Photocatalytic Activity of a Cordierite-Honeycomb-Supported TiO2 Film with a Liquid-Solid Photoreactor.

Anatase nanoparticles in suspension have demonstrated high photoactivity that can be exploited for pollutant removal in water phases. The main drawback of this system is the difficulty of recovering (and eventually reusing) the nanoparticles after their use, and the possible interference of inorganic salts (e.g., sulfates) that can reduce the performance of the photocatalyst. The present work describes the development of a cordierite-honeycomb-supported TiO2 film to eliminate the problems of catalyst recovery. The catalyst was then tested against phenol in the presence of increasing concentrations of sulfates in a specially developed recirculating modular photoreactor, able to accommodate the supported catalyst and scalable for application at industrial level. The effect of SO42- was evaluated at different concentrations, showing a slight deactivation only at very high sulfate concentration (≥3 g L-1). Lastly, in the framework of the EU project Project Ô, the catalyst was tested in the treatment of real wastewater from a textile company containing a relevant concentration of sulfates, highlighting the stability of the photocatalyst.